| Last Modified: 11-29-2007 | 1.6 A | |
| Service Category: Vehicle Interior | Section: Seat | |
| Model Year: 2008 | Model: Sequoia | Doc ID: RM00000333B004X |
| Title: SEAT: REAR NO. 1 SEAT ASSEMBLY: INSTALLATION (2008 Sequoia) | ||
INSTALLATION
HINT:
- Use the same procedure for LH side and RH side.
- The procedure listed below is for the RH side.
1. INSTALL REAR NO. 1 SEAT ASSEMBLY RH
(a) Install the rear No. 1 seat assembly.
NOTICE:
Be careful not to damage the vehicle body.
|
(b) Insert the 2 locating pins through the 2 body holes, move the rear No. 1 seat to its rearmost position and make sure that the inner and outer seat tracks are locked securely. |
(c) Install the 2 bolts.
Torque: 37 N·m (374 kgf·cm, 27 ft·lbf)
|
(d) Operate the seat track adjusting handle to move the seat to the foremost position and make sure that the inner and outer seat tracks are locked securely. |
(e) Install the 2 bolts.
Torque: 37 N·m (374 kgf·cm, 27 ft·lbf)
2. INSTALL REAR NO. 1 SEAT ASSEMBLY RH (w/ Seat Heater System)
(a) Install the rear No. 1 seat assembly.
NOTICE:
Be careful not to damage the vehicle body.
|
|
(b) Insert the 2 locating pins through the 2 body holes, move the rear No. 1 seat to its rearmost position and make sure that the inner and outer seat tracks are locked securely. |
(c) Install the 2 bolts.
Torque: 37 N·m (374 kgf·cm, 27 ft·lbf)
|
|
(d) Operate the seat track adjusting handle to move the seat to the foremost position and make sure that the inner and outer seat tracks are locked securely. |
(e) Install the 2 bolts.
Torque: 37 N·m (374 kgf·cm, 27 ft·lbf)
|
(f) Engage the wire harness clamp and connect the seat heater connector. |
3. INSTALL SEAT TRACK BRACKET COVER INNER (w/ Center Seat)
|
(a) Engage the 9 clips and install the seat track bracket cover. |
4. INSTALL SEAT TRACK BRACKET COVER INNER
|
(a) Engage the 6 clips and install the seat track bracket cover. |
(b) Operate the seat track adjusting handle to move the seat to the rearmost position.
5. INSTALL REAR SEAT TRACK BRACKET COVER INNER
|
(a) Engage the 2 claws and install the rear seat track bracket cover. |
6. INSTALL REAR SEAT TRACK BRACKET COVER OUTER
|
(a) Engage the 2 claws and install the rear seat track bracket cover. |
7. INSTALL REAR DOOR SCUFF PLATE RH
8. INSTALL REAR FLOOR STEP NO. 1 COVER
9. INSTALL REAR FLOOR STEP NO. 2 COVER
10. INSTALL REAR SEAT CUSHION HINGE COVER LOWER RH
|
|